http://docs.mitechisys.com/ 2026-10-04T21:27:19+00:00 http://docs.mitechisys.com/ http://docs.mitechisys.com/lib/tpl/dokuwiki/images/favicon.ico text/html 2019-11-07T22:08:25+00:00 http://docs.mitechisys.com/doku.php?id=installation:dexter:accumulator&rev=1573164505&do=diff Dexter WCN (Accumulator) This note covers WCN Dexter washers. * Reader with back-plate (mounts onto coin-box vault) * Cable harness * Before proceeding, you should assign numbers to each of the machines in the laundry room/building. It is highly recommended that you place number labels on each washer and dryer machine. * Set the machine type and number using the DIP switch on the reader circuit board: See DIP switch settings page to understand how to configure DIP switch posi… text/html 2020-06-22T23:44:09+00:00 http://docs.mitechisys.com/doku.php?id=installation:dexter:aseries&rev=1592869449&do=diff Dexter A-Series Installation This installation note covers A-series Dexter machine. This machine does not have a serial communication interface; our reader just emulates the coin-drop. [ Dexter Washer with card reader] * Reader with back-plate * Cable harness (varies by machine and situation) text/html 2020-11-13T18:13:29+00:00 http://docs.mitechisys.com/doku.php?id=installation:dexter:cseries&rev=1605291209&do=diff Dexter C-Series Washers and Dryers This note covers reader installations on Dexter C-series washers and dryers (single and stack). * Reader with mounting plate for coin box * Cable harness * Power supply (for older Cseries Dryers only). * Before proceeding, you should assign numbers to each of the machines in the laundry room/building. It is highly recommended that you place number labels on each washer and dryer machine. * Set the machine type and number using the DIP switch on… text/html 2016-07-22T16:18:11+00:00 http://docs.mitechisys.com/doku.php?id=installation:dexter:dcd&rev=1469204291&do=diff Dexter Dryer (DCD type) This installation note covers older dexter dryers (DCD type) for upgrades from the EasyCard system. [ Sample Dexter DCD dryer] * MCU (Reader) This reader has 4 studs, and requires 4 corresponding holes to be drilled in the machine * 4-wire Cable harness text/html 2021-03-13T19:05:52+00:00 http://docs.mitechisys.com/doku.php?id=installation:dexter:dl2x&rev=1615662352&do=diff Dexter Coin-op Dryers This note covers reader installations on older Dexter coin-op dryers. The reader uses pulse control. Only one reader per stack is required. * Reader with back-plate * Cable harness * Power supply * Before proceeding, you should assign numbers to each of the machines in the laundry room/building. It is highly recommended that you place number labels on each washer and dryer machine. * Set the machine type and number using the DIP switch on the MCU circuit b…