Table of Contents

Quantum Touch Installation

This installation note covers Quantum Touch controls.

Installation

  1. Turn machine power OFF!

  2. Before proceeding, you should assign numbers to each of the machines in the laundry room/building.

  3. Set the machine type and number using the DIP switch on the back of the card reader:

    See DIP switch settings page for more info.
  4. Mount the reader and connect cable harness to the machine control (signal connector and 2-pin power connector to the 24Vac transformer plug)
  5. Secure the card reader to the machine
  6. Power on the machine
  7. Set the machine for serial communication (Card-Mode) using the touch screen on the machine:




Turn on the Card Reader and go down until you see Serial Payment System:

NOTE: for dryers, you may need to use the Alliance PC software and the IR reader to enable Serial on the machine. I - Activate the reader the the Activation card

Pricing

Unlike for non-Touch models, vend pricing for touch models is set through the machine or Alliance network software.