installation:maytag:gen2nonmetercase
Differences
This shows you the differences between two versions of the page.
|
installation:maytag:gen2nonmetercase [2020/09/05 01:50] maxish |
installation:maytag:gen2nonmetercase [2020/09/05 01:52] (current) maxish |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| 1. Reader | 1. Reader | ||
| - | 2. Cable harness | + | 2. Cable harness. NOTE the reader-side and the machine-side ends of the cable. They look similar Do not mix them up. |
| Line 20: | Line 20: | ||
| - | ===== Variety 1: Front Console ===== | + | ===== Variety 1: Front Control===== |
| - | These readers are for single washers and dryers with controls on the front, such as Washers MNH33PR and MDG28PR. It consists of the bracket and the main enclosure \\ | + | These readers are for single washers and dryers with controls on the front, such as Washers MHN33PR and MDG28PR. It consists of the bracket and the main enclosure \\ |
| {{:installation:maytag:pasted:20160823-135845.png}} \\ | {{:installation:maytag:pasted:20160823-135845.png}} \\ | ||
| - Unscrew 4 “secure” screws on front panel \\ | - Unscrew 4 “secure” screws on front panel \\ | ||
| Line 30: | Line 30: | ||
| - | ===== Variety 2: Dryer with Back console ===== | + | ===== Variety 2: Rear control ===== |
| This reader is for the dryers with controls on the console at the back, such as MDE20PR. | This reader is for the dryers with controls on the console at the back, such as MDE20PR. | ||
| Line 38: | Line 38: | ||
| - Once the reader is secured, power up the machine and apply the Activation card. | - Once the reader is secured, power up the machine and apply the Activation card. | ||
| - | ===== Variety 3: Top Load Washer ===== | ||
| - | The reader for the top-loads, such as MAT20PR, is more narrow than others to allow for the washer lid to swing fully. This reader also uses a different cable than other readers. But the installation process is the same as for Variety 3 shown above. | ||
| Line 48: | Line 46: | ||
| ====== Vend pricing ====== | ====== Vend pricing ====== | ||
| Vend pricing is set on the machine. The reader will reflect and charge the card accordingly | Vend pricing is set on the machine. The reader will reflect and charge the card accordingly | ||
| + | |||
installation/maytag/gen2nonmetercase.txt · Last modified: 2020/09/05 01:52 by maxish
Page Tools
